BRHNG - F111 TY1 CL2 NO LEAD, F-06P13B
- MSDS: BRHNG
- Manufacturer: SEAGRAVE COATINGS CORP OF VA
- Product Name: F111 TY1 CL2 NO LEAD, F-06P13B
- National Stock Number: 8010-00N038827
Product Identification
Product ID:F111 TY1 CL2 NO LEAD, F-06P13B
MSDS Date:02/25/1992
FSC:8010
NIIN:00N038827
MSDS Number: BRHNG
Responsible Party
PORTSMOUTH, VA 23701
US
Emergency Phone: 804-488-4411
Info Phone: 804-488-4411
Cage: 60163
Contractor
Telephone: 757-397-2223
Cage: 60163
Ingredients
TITANIUM OXIDE; (TITANIUM DIOXIDE)
CAS: 13463-67-7
RTECS: XR2275000
Fraction By Weight: <15%
OSHA PEL 15 MG/M3 TDUST
ACGIH TLV: 10 MG/M3 TDUST; 9293
ZINC OXIDE
CAS: 1314-13-2
RTECS: ZH4810000
Fraction By Weight: <10%
OSHA PEL 15MG/M3 TDUST/5 FUME
ACGIH TLV: 10MG/M3 TDUST; 9293
15 MG/M3 TDUST;5 MG/M3 RDUST.
CAS: 1317-65-3
RTECS: EV9580000
Fraction By Weight: <15%
OSHA PEL SEE INGREDIENT NAME
ACGIH TLV: 10 MG/M3 TDUST
TALC (POWDER), CONTAINING NO ASBESTOS FIBERS; (TALC)
CAS: 14807-96-6
RTECS: WW2710000
Fraction By Weight: <5%
OSHA PEL 2 MG/M3 RDUST
ACGIH TLV: 2 MG/M3 RDUST
STODDARD SOLVENT; (MINERAL SPIRITS (PETROLEUM SOLVENT)).
CAS: 8052-41-3
RTECS: WJ8925000
Fraction By Weight: <35%
OSHA PEL 500 PPM
ACGIH TLV: 100 PPM; 9293
0.5 @ 20C.
CAS: 64741-65-7
Fraction By Weight: <1.0%
OSHA PEL 300 PPM
ACGIH TLV: 300 PPM
Hazards
LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:NO Ingestion:YES
Reports of Carcinogenicity:NTP:NO IARC:NO OSHA:NO
Health Hazards Acute and Chronic:INHALATION: IRRITATION TO RESPIRATORY
TRACT; HEADACHE, DIZZINESS AND NAUSEA. SKIN: PRIMARY IRRITATION.
EYE: PRIMARY IRRITATION.
Explanation of Carcinogenicity:NOT RELEVANT.
Effects of Overexposure:SEE HEALTH HAZARDS.
Medical Cond Aggravated by Exposure:PRE-EXISTING SENSITIVITY TO
SOLVENTS CAN CAUSE A HEIGHTENED REACTION TO EXPOSURE TO THIS
PRODUCT.
First Aid
First Aid:INHALATION: REMOVE TO FRESH AIR, RESTORE BREATHING. CONSULT
PHYSICIAN. SKIN: FLUSH WITH WATER. EYE: FLUSH IMMEDIATELY WITH
LARGE AMOUNTS OF WATER FOR AT LEAST 15 MINUTES. CONSULT A
PHYSICIAN. INGESTIO N: CALL MD IMMEDIATELY .
Fire Fighting
Flash Point Method:TCC
Flash Point:100F,38C
Lower Limits:1%
Upper Limits:6%
Extinguishing Media:FOAM, WATER FOG, DRY CHEMICAL, CARBON DIOXIDE.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPRVD SCBA & FULL PROT EQUIP
. WATER MAY BE USED TO COOL CLSD CNTNRS TO PVNT PRESS BUILD-UP &
POSS AUTOIGNIT/EXPLO WHEN EXPOS TO (SUPDAT)
Unusual Fire/Explosion Hazard:KEEP CONTAINERS TIGHTLY CLOSED. ISOLATE
FROM HEAT, SPARKS, AND OPEN FLAME. CLOSED CONTAINERS MAY EXPLODE
WHEN EXPOS TO EXTREME HEAT.
Accidental Release
Spill Release Procedures:AVOID BREATHING SOLVENT VAPOR. ENSURE ADEQUATE
VENTILATION. AVOID SPARKS, FLAMES, AND ANYTHING WHICH COULD CAUSE
FIRE.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.
Handling
Handling and Storage Precautions:STORE IN A COOL DRY AREA WITH
VENTILATION SUITABLE FOR STORING MATERIALS SHOW IN INGREDIENTS
SECTION.
Other Precautions:PROVIDE RESPIRATORY PROTECTION AGAINST FUMES
GENERATED DURING BURNING.
Exposure Controls
Respiratory Protection:NIOSH/MSHA APPROVED RESP TYPES SUITABLE FOR
MATLS IN INGREDIENTS SECTION RECOM. NIOSH/MSHA APPROVED
CHEMICAL/MECHANICAL FILTERS RECOMMENDED WHEN VENTILATION IS
RESTRICTED. NIOSH/MSHA APPRVD AIRLINE TY PE RESP/HOODS RECOM IN
CONFINED AREAS.
Ventilation:SUFF VENT, IN VOL & PATTERN, SHOULD BE PROVIDED TO KEEP AIR
CONTAM BELOW CURRENT APPLIC OSHA PEL OR ACGIH'S TLV LIMIT.
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEM WORK GOG/FULL LGTH FACESHLD .
Other Protective Equipment:USE PROTECTIVE CREAMS WHERE SKIN CONTACT IS
LIKELY. REMOVE AND WASH CONTAMINATED CLOTHING BEFORE REUSE.
Work Hygienic Practices:WASH HANDS BEFORE EATING OR SMOKING. SMOKE IN
DESIGNATED AREAS ONLY.
Supplemental Safety and Health
% VOLATILES: 32.9 (WT); 54 (VOL). FIRE FIGHT PROCEDURE: EXTREME HEAT.
Chemical Properties
Boiling Pt:B.P. Text:302F,150C
Vapor Pres:SEE INGS
Vapor Density:HVR/AIR
Evaporation Rate & Reference:SLOWER THAN ETHER
Solubility in Water:INSOLUBLE
Appearance and Odor:GRAY LIQUID, ALIPHATIC SOLVENT ODOR.
Percent Volatiles by Volume:SUPDAT
Stability
Stability Indicator/Materials to Avoid:YES
NONE KNOWN.
Stability Condition to Avoid:NONE SPECIFIED BY MANUFACTURER.
Hazardous Decomposition Products:AS W/ANY ORG MATL, COMBUST WILL PRDCE
CARBON DIOXIDE & PROBABLY CARBON MONOXIDE. OXIDIZING MATLS CAN
CAUSE VIGOROUS RXN.
Disposal
Waste Disposal Methods:SOAK LIQUIDS WITH SAWDUST OR RAGS AND REMOVE.
FLUSH WITH WATER IF POSSIBLE. AVOID SKIN CONTACT. DISPOSAL SHOULD
BE IN ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS.
Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.